Question: Stone Crusher production process Frequently Asked Questions

Stone Crusher production process Frequently Asked Questions

Stone Crusher as the preferred device of the artificial sand is widely used for a variety of industries broken . Most concerned about the Sand Sand production and Sand in the course of which the problem occurs . Below to introduce common problems and solutions under the sand making machine in the production process for users' reference .

(1)Sand making machine body swing . System sand body swing feed particle size is too large , then increase the load on the sand making machine , resulting in adjust the feed particle size , impeller channel clogging material , you only need to remove the channel sealing , wear block had to wear caused by emphasis on replacement wear a full set of body .

(2)In the system of sand production , metal percussion . This is due to the sub - feeder and rotor collided , adjusting feeder installation position can be .

(3)Product particle size is too large . This is mainly caused due to the sand making machine belt too loose , just put the belt tune tight tighten bolts on it, but this is easily overlooked in the production process .

Thank you for your interest in YiFan. Please use any of the methods below to get in touch with us.
Add: The Middle of Zhengyuan Road, Xingyang Eastern Development Zone.
zip:450100
E-mail：yifanseo@yfmac.com
MSN On line: yifancrusher@yahoo.cn
ICQ: 639607958 QQ: 2502761202
Tel: +86-371-64628852 Fax: +86-371-64628872
The article by Stone Crusher,Crushing Equipment Yifan Machinery Editor: http://www.stonecrusher.org/, please indicate the source , little effort , thank you .

Message Online